FERMAX DUAL DOX PLUS Regenerator 1S 3268

The FERMAX DUAL DOX PLUS Regenerator 1S 3268 can be used for the following purposes:
- Increasing the capacity of the installation in distance and/or terminal load. The regenerator has to be connected at a point where the signal is acceptable (e.g. where a monitor is working properly).
- 1. Board distance extension.
- 2. Monitor extension.
- 3. Signal regeneration.

- Isolation of sections (trunks,...). The two sections between which it is installed are isolated from short circuits, load and signal reflections.

- When fed from one port, the regenerator allows a maximum current of 1.6 A to pass to the other port.

- In addition, in multi-channel regenerator mode, simultaneous conversations can be established in different blocks.

Features of the FERMAX DUAL DUOX PLUS 1S 3268 Regenerator:

Mounting can be carried out either by screwed fixing or DIN rail installation.
Dimensions: 86 (H) x 89 (W) x 26 (D) mm.

Connection
- The regenerator can be powered from either of its two ports, but not both simultaneously. If this is the case, the microswitch 4 of SW1 must be placed in the OFF position to isolate the current from both ports.

DUOX System: It is the first fully digital system in non-polarised two-wire technology. It is the most technologically advanced system in the world, allowing rapid installation with only two wires. The most simplified and advanced installation system on the market. It maximises the capabilities of intercom systems thanks to the digital transmission of audio and video. Duox offers maximum simplicity of installation that enables the transmission of all signals: power, audio, video and data with maximum capacities. Allows to manage - From 1 to 999999 homes:

- Calls from Pushbutton Panel: 99.

- Calls from Keypad: - Sub-Block: 99. - Block: 9999. - General Entry: 999999. - From 1 to 10 panels:

- Number of Panels: - General Inputs: 10. - Block: 10. - Sub-Block: 10. The maximum distance will depend on the topology and cable of the installation.

See table of sections and distances for more details. With DUOX you have maximum versatility, thanks to the stability and robustness of the signal transmission of this completely digital system that avoids any possible reflection and interference in the installation. The DUOX amplifier includes a voice synthesiser as standard. When the door opener is activated, a message is emitted: "door open, close after entering". Up to 3 terminals (telephones/monitors) can be installed in each flat. The home terminals require simple programming. This programming assigns a call code to each terminal.

Communication is private. Wiring: Any type of cable can be selected: parallel, twisted pair and UTP CAT5 in new construction, and even the existing wiring can be used in replacement works (5 wires, 2-wire bell or old 4+N cable). 2 wires without polarity. It is recommended to see the table of sections-distances-terminals-power supply.